Using a ScreenBeam 1100 Plus with an HDL410 system
    • 18 Jun 2024
    • PDF

    Using a ScreenBeam 1100 Plus with an HDL410 system

    • PDF

    Article summary

    The ScreenBeam® 1100 Plus platform can be integrated with the Nureva® HDL410 system to deliver superior audio and wireless display capabilities — perfect for enhancing collaboration in office and learning environments.

    Before starting

    Set up the HDL410 system by following the steps in the get started guide:

    Get started with the HDL410 system

    On the ScreenBeam 1100 Plus

    1. Ensure the ScreenBeam 1100 Plus has the latest version of the firmware.

      • Firmware version 11.1.15.6 or newer is required.

    2. Connect the HDL410 to the USB 3.0 port on the back of the 1100 Plus.

    3. Connect a USB camera to a USB-A port on the 1100 Plus.

    4. Connect an HDMI cable from the HDMI-out port of the 1100 Plus to the in-room display.

    Important: The Screenbeam USB Pro switch is currently not compatible with the HDL410 system.

    On the in-room computer

    1. Download and install the ScreenBeam Conference software.

    2. Follow the steps shown on-screen to install the software.

    3. Launch the ScreenBeam Conference software and connect to the ScreenBeam device.

    4. In the conferencing platform’s audio settings, set the speaker and microphone as follows:

      • Speaker = Digital Output (ScreenBeam xxxx)

      • Microphone = In-Room Microphone (ScreenBeam Virtual Audio)

    Resources from ScreenBeam

    Downloads and documentation for the ScreenBeam 1100 Plus


    Was this article helpful?