Can a USB extender be used with a Nureva audio system?
- 17 Oct 2024
- Print
- PDF
Can a USB extender be used with a Nureva audio system?
- Updated on 17 Oct 2024
- Print
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
Yes, a USB extender can be used with Nureva® audio systems. Nureva recommends using the USB extenders listed below. These extenders meet our standards for audio quality and reliability. Using USB extenders that have not been validated with Nureva devices may result in reduced audio conference quality due to increased latency and dropped data packets.
Active USB extenders
Brand | Description | Model | Product webpage |
|---|---|---|---|
Icron | USB 2.0, dual port, CAT5e/CAT6/CAT7, 100 m (330') extender | Ranger 2312 | |
Monoprice | USB-A Male to USB-A Female 2.0 Extension Cable — Active 20/28 AWG Repeater, Black 16' | 8751 |
The Icron Ranger® 2312 is dual-port and allows the connection of a third-party camera and other third-party USB devices to the in-room computer when needed.
HDBaseT extenders
Brand | Description | Model | Product webpage |
|---|---|---|---|
Valens | USB & Power 100m/328 ft. Extender | EVX6-USB-KT-POE | |
Atlona | HDBaseT Extender with HDMI Input and USB Hubs | AT-OME-EX-KIT-LT |
To use HDL200, HDL310 and HDL410 systems with HDBaseT extenders, setting the USB speed to Full Speed (USB 1.1) is necessary for a successful combination. HDL300 and Dual HDL300 systems can be used with HDBaseT extenders without changing the USB speed.
HDL200 systems — Adjusting the USB speed for the HDL200 system
HDL310 and HDL410 systems — Adjusting the USB speed with the Nureva App
Alternative to USB extenders
The HDL300, Dual HDL300, HDL310 and HDL410 systems include Ethernet cables used for Power over Ethernet (PoE). USB extenders can be avoided by using a long PoE cable between the connect module and the speaker bar. This will allow the connect module to be placed closer to the host device.
Supplied Ethernet cable specifications
CAT6
SSTP (screened-shielded twisted pair)
26 AWG cable
50' (15 m)
Replacement Ethernet cable specifications
If a longer or replacement cable is needed, an Ethernet cable with the following specifications can be used:
CAT5e minimum
SSTP (screened-shielded twisted pair)
Minimum 26 AWG cable for cable runs up to 164' (50 m)
Minimum 24 AWG cable for cable runs up to 246' (75 m)
Minimum 23 AWG cable for cable runs up to 328' (100 m)
Note: When using third-party cables, ensure the cable meets the applicable country, regional and local electrical codes or ordinances relating to that type of cable and related accessories.
Was this article helpful?