This article outlines how to use the Nureva® Dual HDL300 audio conferencing system with the Zoapi Hub Meet meeting room solution.
Before starting
Set up the Dual HDL300 system by following the steps in the get started guide:
On the Nureva Dual HDL300
Connect the included power cable to the connect module of the Nureva Dual HDL300.
Plug the included USB Type A-B cable from the Dual HDL300 to a USB-A 3.0 port on the back of the Zoapi Hub Meet.
On the Zoapi Hub Meet
Ensure the Hub Meet is switched on and fully started up.
Enter your credentials on the Hub Meet’s UC&C application of your choice.
Set the default audio device to Nureva Audio.
Bring your own device mode
The Nureva Dual HDL300 microphones are supported for use with the UC&C applications installed directly on the Zoapi Hub Meet. When the Zoapi Hub Meet is used in BYOD mode, the Dual HDL300 provides speaker output only and the microphones are not available.
Resources from Zoapi
The technical information in this article, including specifications and recommendations, is provided for customer convenience. The accuracy of this information is not guaranteed and is subject to change without notice. Please check the user manuals and related documentation from each product manufacturer to ensure that your setup meets the proper recommendations.