Connecting the HDL310 system

• Connect the provided Ethernet cables to the RJ45-1 port on the connect module
• Run the Ethernet cables to the RJ45 port on the microphone and speaker bar
• Connect your own CAT5E Ethernet cable to the network port on the back of the connect module
• Plug the CAT5E Ethernet cable into an available network port (router, modem, wall jack)
• Connect the provided power supply to the connect module and plug it into an available outlet or power bar

• Once powered up the HDL310 will automatically calibrate
  • Please remain quiet in the room until calibration is complete  
• Once calibrated the HDL310 system may require a firmware update

Connecting a computer

To participate in an audio or video conference a computer is required. 

• Using the provided USB cable, connect to the USB-B port on the connect module
• Run the cable to the computer, connecting to a USB-A port

Once the conference has been completed the computer can be removed from the connect module.

Overheating

• Do not block the vents on the top, bottom or back of the connect module
• Ensure adequate space between all vents and other objects to promote airflow and cooling
• These vents are required to keep the circuits from overheating
• Avoid installing the connect module in a confined space

Enrollment code

The HDL310 system is network-enabled, allowing easy enrollment into the Nureva Console cloud application. An enrollment code is provided on a label that is found at the bottom of the connect module. It is recommended to record the enrollment code before installing the connect module.

NOTE: This code is specific to the HDL310 system and cannot be used by other Nureva systems.