Yes, Nureva has determined that the Lifesize Icon 600 conference room solution works with the HDL300 and Dual HDL300 systems when configured as shown in this article.
To get started, first check that the HDL300 is up-to-date and set up correctly:
- Connect the PoE cable (provided) to the RJ45-1 port on the connect module to the rear port on the HDL300 system
- Plug in the 54VDC power supply and connect a laptop to the connect module using the USB-A to USB-B cable (provided)
- Download and run Nureva Console Client
- In Nureva Console Client, under
- Product updates => Check for firmware updates
Audio conferencing system
- Aux out => Microphone out (Mic level)
- Sleep mode => Disable
- Auxiliary ports
- Disconnect the connect module from your laptop and remove the USB cable.
Creating custom cables
Prepare two 3.5 mm jack cables with the three pins positive (+), negative (–) and ground (G) per Nureva auxiliary port recommendations. Label one Cable 1 and the other Cable 2.
See the article What kind of auxiliary jacks are compatible with the HDL300 system? for more information.
On the HDL300 connect module
- Plug Cable 1 into the Aux out port
- Plug Cable 2 into the Aux in port
- Connect the PoE cable (provided) to the RJ45-1 port on the connect module to the rear RJ45 port on the HDL300 system
- Plug in the 54VDC power supply
On the Lifesize Icon 600 CODEC
- Plug Cable 1 into Microphone in on the I/O panel
- Plug Cable 2 into the Speaker out on the I/O panel
- Connect the Lifesize Icon 600 video system to the network via the LAN port
Navigate to the IP address of your Icon 600 video system portal from the web browser
- Navigate Account Settings => Preferences => Audio
- Set Audio Device to Echo Cancelling Speakerphone (HDL300)
- Disable Acoustic Echo Canceller for Microphone in (if active)
- Save all changes and Exit
To start a video conferencing call, see the article Does the HDL300 system work with audio conferencing (UC&C) software? for more information on setting up and using the LifeSize UC&C client.
NOTE: The Nureva Aux In / Out connections are single-ended, unbalanced signals with default maximum output signals as given in the table below. Any equipment requiring voltages below these levels may result in clipping, distortion, and in extreme cases, damage to connected systems. Equipment requiring voltages above these levels will not be adequately driven by the HDL300 system’s output signal and may result in quiet / no audio on the channel. Before connecting to the Nureva Connect Module, ensure the third-party device voltage levels are adequate or adjusted properly by additional interfacing hardware.
NOTE: The technical information provided in this article, including specifications and recommendations, is provided for customer convenience. The accuracy of this information is not guaranteed and is subject to change without notice. Please check the user manuals and related documentation from each product manufacturer to ensure that your setup meets the proper recommendations.