Using a Lightware UCX-2x1-HC30 with an HDL410 system

The Lightware UCX-2x1-HC30 switcher works with the Nureva^® HDL410 system and other USB peripherals to effortlessly share between an in-room computer and a bring-your-own-device (BYOD) setup.

Before starting

Set up the HDL410 system by following the steps in the get started guide:

Get started with the HDL410 system

On the Lightware UCX-2x1-HC30

1. Connect a USB-B 3.0 cable from USB-B input 2 (IN 2) to a USB-A 3.0 port on the in-room computer.

2. Plug a USB-C cable into input 1 (IN 1). This cable is used to connect to a BYOD and provides up to 60 W of charging.

3. Connect an HDMI cable from HDMI input 2 (IN 2) to the HDMI-out port on the in-room computer.

4. Connect the USB cable from the HDL410 connect module to a USB-A port at the rear of the UCX-2x1-HC30.

5. Connect an HDMI cable from the HDMI-out of the UCX-2x1-HC30 to the in-room display.

6. Connect an Ethernet cable from the UCX-2x1-HC30 to the network. The UCX-2x1-HC30 supports Ethernet pass-through to both devices.

7. On both the in-room computer and BYOD, set the default speaker and microphone to the HDL410.

Important: For input 1 (IN 1), a USB 3.1 Gen 1 compatible cable must be used.

Resources from Lightware

Lightware support

The technical information in this article, including specifications and recommendations, is provided for customer convenience. The accuracy of this information is not guaranteed and is subject to change without notice. Please check the user manuals and related documentation from each product manufacturer to ensure that your setup meets the proper recommendations.