Using a Lightware UCX-2x1-HC30 with an HDL300 system
    • 01 Apr 2025
    • PDF

    Using a Lightware UCX-2x1-HC30 with an HDL300 system

    • PDF

    Article summary

    Using the Nureva® HDL300 system with the Lightware UCX-2x1-HC30 switcher delivers a seamless and versatile solution for modern meeting spaces. The UCX-2x1-HC30 works with the HDL300 and other USB peripherals to effortlessly share between an in-room computer and a bring-your-own-device (BYOD) setup.

    Before starting

    Set up the HDL300 system by following the steps in the get started guide:

    Get started with the HDL300 system

    On the Lightware UCX-2x1-HC30

    1. Connect a USB-B 3.0 cable from the IN 2 USB-B input to a USB-A 3.0 port on the in-room computer.

    2. Plug a USB-C cable into IN 1. This cable is used to connect to a BYOD device and provides up to 60 W of charging.

    3. Connect an HDMI cable from the IN 2 HDMI input to the HDMI-out port on the in-room computer.

    4. Connect the USB cable from the HDL300 connect module to a USB-A port at the rear of the UCX-2x1-HC30.

    5. Connect an HDMI cable from the HDMI-out of the UCX-2x1-HC30 to the in-room display.

    6. Connect an Ethernet cable from the UCX-2x1-HC30 to the network. The UCX-2x1-HC30 supports Ethernet pass-through to both devices.

    7. On both the in-room computer and BYOD device, set the default speaker and microphone to the HDL300.

    Important: For input 1 (IN 1), a USB 3.1 Gen 1 compatible cable must be used.

    Resources from Lightware

    Lightware support

    The technical information in this article, including specifications and recommendations, is provided for customer convenience. The accuracy of this information is not guaranteed and is subject to change without notice. Please check the user manuals and related documentation from each product manufacturer to ensure that your setup meets the proper recommendations.


    Was this article helpful?