CV30 camera remote control

Functions and troubleshooting
Last Updated: May 17th, 2022

CV30 camera remote control functions

Remote control codes

The CV30 camera's remote control uses an infrared transmission protocol. If an infrared (IR) blaster (transmitter) is used to control the camera, then the following codes can be programmed.

Function Code Function Code
1F E0 Menu (enter/exit OSD) 0X17E8
  Volume down ( - )
1C E3 Enable/disable tracking 0X13EC
  Volume up ( + ) 07 F8 Set 0X48B7
  Up 0X50AF Num 1 0X0FF0
  Down 0X53AC Num 2 0X49B6
  Left 0X51AE Num 3 0X1AE5
  Right 0X52AD Zoom in 0X4AB5
  Home 0X1CE3 Zoom out 0X54AB


If the remote control is not operating correctly, try the following:

  1. Point the remote at the center of the camera lens, at a 90-degree angle
  2. Move closer to the CV30 (optimum range is within 20 feet)
  3. Confirm that the front of the remote is not obstructed
  4. Confirm that the path between the remote control and camera are not blocked
  5. Replace the batteries

Was this article helpful?

Can’t find what you’re looking for?

Contact Support