Popular topics: Downloads Can I connect my computer wirelessly to the projector? HDL300 system installation guide Download Room Manager Room Manager features overview ► WM408i installation guide and drawings ► HDL300 system integration guide Microphone clearance requirements and recommendations More download options Does the HDL300 system work with audio conferencing (UC&C) software? Using the auxiliary ports on the HDL300 system Span Workspace technical requirements Installation guides and drawings Getting started with your HDL300 system HDL300 and Dual HDL300 system connection diagrams Installing a Dual HDL300 system Is the HDL300 system compatible with the Cisco® SX80? Can I switch between a single HDL300 and Dual HDL300 system? Copying and pasting onto the canvas Setting up Jira® for Span Workspace ►

Trimming your WhisperTek™ surface

Your WhisperTek surface can be trimmed down to size with a few simple tools:

    Retractable utility knife with a fresh blade

    48" (120 m) long standard drywall T-square

    Hard surface  – such as a milled and planed flat board

    10 cm wide painter's tape – or masking tape

    Work gloves

    Pen


Trimming your WhisperTek surface

  1. Lay the WhisperTek surface on a hard surface on the floor. The hard surface will protect the floor from the knife blade.
  2. Mark the cutline at 86" (2.18m)
  1. Align the T-square to the cutline. You can tape the left edge of the T-square to keep it from moving.
  1. Drag the knife edge along the full length of the cutline to score the surface. Do not press too hard on your first cut.
  2. Repeat the cut 2–3 times until the knife blade cuts through the WisperTek surface into the hardboard

For new WM307i installs, order the WhisperTek HD surface.



Last updated: September 5, 2017

Was this article helpful?

Can’t find what you’re looking for?

Contact Support

1.844.370.2111